Caterpillar Excavator Cylinder Gasket of 345c C13

Caterpillar Excavator Cylinder Gasket of 345c C13
Model NO.: 221-9392
Pressure: Medium Pressure Mechanical Seals
Standard: Standard
Trademark: Caterpillar
Structure: Double-End
Speed: General Speed Mechanical Seal
Performance: Wear
Transport Package: Netural Packing &Te Packing
main bearing,Caterpillar C13 the gland,Caterpillar C13 the gland bolts,Caterpillar C13 nuts,Caterpillar C13 gaskets,Caterpillar C13 rubber ring,Caterpillar C13 an adjusting shim,Caterpillar C13
When ,Caterpillar Excavator Cylinder Gasket of 345c C13 is water in the pump, and when the motor is running normally, the pump is blocked with the palm of the pump, and the suction is insufficient.3.2 causes and methods of troubleshooting(1) wear of impeller or water seal. A new impeller or water seal should be replaced.(2) the water intake of the pump, the outlet of the water pump, and the seal of the side cover are not strict. The rubber pads should be tightened or replaced.(3) the ,Caterpillar Excavator Cylinder Gasket of 345c C13 is slightly corroded and leaking. Fill the air leak with 302 glue.(4) the winter cold is improper, the pump diaphragm is cracking. Use 302 glue to repair or replace the new ,Caterpillar Excavator Cylinder Gasket of 345c C13.(5) the impeller is not mounted. The impeller should be adjusted to the wall of the pump as if it is not attached to the wall.(6) the intake hole of the pump is blocked by the sundries. The upper cover of the ,Caterpillar Excavator Cylinder Gasket of 345c C13 should be removed to remove the sundries.(7) the axial movement of the rotor of the motor. Both ends of the rotor bearing will be removed, cut several pits with a sharp mouth in the rotor bearing, the bearing load or replacement bearings.(8) the screw components of the screw type self-priming pump are worn out. The new screw assembly should be replaced.